第3篇:vscode搭建esp32 arduino开发环境

发布于：2023-08-24 ⋅ 阅读:(68) ⋅ 点赞:(0)

第1篇:Arduino与ESP32开发板的安装方法

第2篇:ESP32 helloword第一个程序示范点亮板载LED

1.下载vscode并安装

https://code.visualstudio.com/

运行VSCodeUserSetup-x64-1.80.1.exe

2.点击扩展，搜索arduino,并点击安装

3.点击扩展设置，配置arduinoIDE安装路径

根据arduino.exe的安装目录进行配置

4.输入Chinese,安装中文语言包

5.安装其余插件

6.创建项目目录

D:\Arduino_Project\esp32_dev

D:\Arduino_Project\esp32_dev目录下创建blink2.txt 把txt后缀改为blink2.ino

7.用vsocde打开文件夹

关闭提示Arduino CLI提示

7.打开ino，拷贝blink 点亮led的测试程序

/*
  Blink

  Turns an LED on for one second, then off for one second, repeatedly.

  Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
  it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to
  the correct LED pin independent of which board is used.
  If you want to know what pin the on-board LED is connected to on your Arduino
  model, check the Technical Specs of your board at:
  https://www.arduino.cc/en/Main/Products

  modified 8 May 2014
  by Scott Fitzgerald
  modified 2 Sep 2016
  by Arturo Guadalupi
  modified 8 Sep 2016
  by Colby Newman

  This example code is in the public domain.

  https://www.arduino.cc/en/Tutorial/BuiltInExamples/Blink
*/

// the setup function runs once when you press reset or power the board
//esp32 dev module

#define led 2
void setup() {
  // initialize digital pin LED_BUILTIN as an output.
  Serial.begin(115200);
  pinMode(led, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000); 
  Serial.println("led is high");                      // wait for a second
  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);    
   Serial.println("led is low");                    // wait for a second
}